Using ēno
Steelcase 20
Correct stylus orientation
For optimum performance:
o
hold the stylus at a slight angle (not 90 degrees from the whiteboard).
o
hold the stylus with LED facing up toward the ceiling as shown below.
The stylus Bluetooth connection
If a notification appears briefly in the lower left corner of the whiteboard telling you that
“Your stylus is disconnected”, the stylus has become temporarily disconnected from
communication with the host computer.
This commonly occurs if:
o
the stylus is turned off by replacing the stylus cap. To resume communication, simply
remove the stylus cap.
o
the stylus has automatically entered sleep mode to save battery life after a period of
inactivity. To resume communication, simply replace the stylus cap and then remove
it again.
o
the stylus moves further than approximately 32 feet (10 m) from the host computer.
To resume communication, move closer to the host computer, replace the stylus
cap, and then remove it again.
o
the stylus battery needs to be replaced. Refer to “Install the ēno stylus battery” on
page 9.
