STARPLUS Starplus DHS-L, Technical Manual

Page: 214 / 294

3-144 Voic e Mai l
Chapter 3 - Key Station Features, Operation, and Programming
Programming
The DHS-L enables the user of any DHS-L key telephone to monitor callers leaving a
message in their voice mail box. When a caller is routed from a ringing telephone to a
user voice mail box, an alert is presented to advise the user that the feature can be
invoked.
Default
The DHS-L VM Monitor Time is set for 6 sec, and is variable at 10/20/30/40/50/60 sec.
Conditions
†
You may press [MUTE] while monitoring a call to be connected to the caller.
†
When you answer a call the programmed Disconnect Digits Table digits are sent to
the voice mail port.
†
You will hear the alert tone regardless of whether your telephone is idle or busy or in
speakerphone or handset mode.
†
When the new timer VM MON TIME expires the opportunity to invoke the feature has
past.
†
The new timer VM MON TIME is added to the Call Handling category of programming
and will allow (10/20/30/40/60) second duration to be programmed.
†
When you use the VM Monitor feature, a conference is established between yourself,
the voice mail port associated to the call, and the caller leaving the voice mail
message.
†
If you are on a call when the VM Monitor alert tone signals you, you may place the call
on hold to enable the VM Monitor feature.
†
You may exit the VM Monitor mode by hanging up the handset, pressing [SPKR], or
pressing [CLEAR].
†
You may monitor only one call at a time.
Port
Single Line Telephone ports that are to be used for connection to a Voice Mail system
must be assigned type VM to provide longer DTMF tones. This identifies the port to the
system software for special handling.
Default
DHS-L Single Line Telephone ports are set to N (NO), not assigned as a VM port.