- 37 -
11-2. Auto Cutter Specifications
(1) Cutting method:
Guillotine type
(2) Cutter modes:
Switchable between full cut and partial cut (leaves one uncut portion in center of paper)
(For instruction on how to switch the mode, see section 4-4, “Changing the Cutter Mode”.
(3) Cutting duty cycle:
Min. 3 seconds/cut
(4) Paper thickness:
65 µm to 150 µm
11-3. Interface Specifications
USB standard:
Type-B
Options
Parallel:
36-pin Amphenol
IEEE1284 compliant (Compatibility and Nibble modes)
Serial RS-232C:
D-SUB 25 pin
Ethernet:
RJ-45
PoweredUSB:
FCI 69913-104LF (1 x 8 right-angle type)
11-4. Power Supply Specifications
(1) Operating voltage:
24 V DC ± 10%
(2) Current consumption (24 V DC, room temperature):
Standby
Approx. 0.12 A
ASCII printing
Approx. average 1.56 A
100% duty cycle printing
Approx. peak 7.84 A
(Solid printing)
Approx. average 4.2 A
Note:
Continuous solid printing should be 10 seconds or less.
(3) Power connector pinout:
Pin number
Function
1
+24 V
2
GND
3
N.C
Shell
Frame ground
Note:
The optional AC adapter (PS60A-24B) has been designed specifically for this printer.
Other AC adapters may not meet the EMC technical standards.
If you are preparing your own power supply, without using the optional AC adapter, note the following points.
• Use a power supply that is rated 24 V DC and 2.1 A, or equivalent.
(Select a power supply with current capacity that is appropriate for the actual printing ratio.)
• Use a power supply that complies with SELV output or LPS (Limited Power Source).
• Take into consideration the noise in the environment that the printer is installed in, and take appropriate mea-
sures to protect the printer from static electricity, AC line noise, etc.
1
2
3
DC
24V
DK
Power connector