Stanley SPT-182-570, Original Instructions Manual

Page: 10 / 233

10
6. Assembly
Following the assembly directions below, you will
assemble the snow thrower in a few minutes
Engine
1. Remove wing nut and washer from the air
filter cover.
2. Rotate the air filter cover by 180o so that
the primer faces outside.
3. Install air filter cover and tighten wing nut.
Handlebars
1. Align the holes in the handlebars with the
side plates and secure handlebars with
the screws and the washers until they are
finger tight.
2. Remove the axle pins and slide the wheels
on the axle. Insert each axle pin through
the hole in each wheel hub and through the
hole in the axle.
3. Secure control panel to the handlebars with
screws, washers and nuts until they are
finger tight.
4. Ensure that the handles are at the same
height, and then tighten all the fasteners
securely.
G
B