ST HDS2 Series, User Manual

Page: 48 / 67

4 - Emulator Features ST7MDTU3-EMU2B Emulator User Manual
48/63
2 Right-click the mouse while the mouse pointer is anywhere in the Hardware
Events window.
3 Choose New Hardware Event from the contextual menu. The Hardware event
settings dialog box will open as below.
4 Choose the trigger output that you wish the signal to be sent to (i.e. OUT1 or
OUT2) and check the
Enabled box.
5 You may trigger output signals by setting an event on any of the following:
- a whole variable—creating an event for synchronization, which enables
you to preset the pulse synchronization for external equipment connected
to the output trigger.
- a single address—also creates an
event for synchronization (see above).
- a range of addresses—creating an event to measure time, which enables
you to measure the time elapsed during a subroutine execution.
A positive impulse is emitted on OUT1 and OUT2 when a specific condition is met.
This impulse lasts for one Clock cycle.