ST HDS2 Series, User Manual

Page: 15 / 67

ST7MDTU3-EMU2B Emulator User Manual 2 - Getting Started
15/63
If you are using the SDIP32 package, proceed as follows:
Solder the joined generic probe (ref.: DB467) and ST72F63-TEB (ref.: DB465) to
your application board (see Figure 8 ).
Step 4: Connecting the emulator power supply
Warning: Make sure that both the ST7MDTU3-EMU2B and the application are OFF before making
any connections.
1 Connect the external power supply provided with the emulator to the rear panel
of the mainframe using a 5-pin DIN connector.
2 Plug the power supply into the mains using the supply cable provided.
Mains voltage specifications:
Step 5: Powering up
1 Check the ST7 HDS2 operating voltage (110 V/220 V) indicated on the label on
the power supply. Contact your dealer if this voltage does not correspond to
your mains’ power supply.
Figure 8: SDIP32 Package Connections
AC voltage: 100 V to 240 V
Frequency: 50 to 60 Hz
J2
J1
Application Board
ST7 Generic Probe
(ref.: DB467)
ST72F63 TEB (ref.: DB465)