ST HDS2 Series, User Manual

Page: 12 / 67

2 - Getting Started ST7MDTU3-EMU2B Emulator User Manual
12/63
Be sure to use the parallel cable provided with the emulator—using a longer parallel cable
may cause emulator malfunctions.
Step 2: Connecting the Emulator to the Probe
1 Ensure that the application and the emulator are powered-off.
2 Plug the two 50-wire flat cables into the J1 and J2 connections on the probe, as
described below (refer also to
Figure 5
):
Figure 4: Connecting the Emulator to the PC
ST7 HDS2 emulator
(ref.: MB176)
ST7-Generic Probe
(ref.: DB467)
Upper cable
Lower cable
J2
J1
Figure 5: Connecting the Emulator to the Generic Probe
2
1
SUBD25 connector
rear panel
to LPT1 or LPT2
Red Line
ST7 HDS2
Side View
50 pin male connectors
J1 J2
DB467