ST7MDTU3-EMU2B Emulator User Manual
3 - STVD7
19/63
Enter the paths for the toolchains that you use (i.e. any or all of the Hiware,
Cosmic or ST7 ASM toolchains) and click
OK. (The default paths for each
toolchain are shown below.)
3
If you choose
Cancel, you will be prompted again to enter the toolchain paths
the next time you launch STVD7.
Note:
You may modify the toolchain path at any time from within STVD7—simply select
Project>Toolchain Paths from the main menu to access the dialog box above.
3.3
About STVD7 debugging features
A number of advanced features are included in the STVD7 software:
•
Data Breakpoints on the occurrence of a memory access via a read operation
or a write operation, or both.
•
Instruction Breakpoints on the occurrence of an opcode fetch.
•
A Logical Analyser that allows you to control either the recording of the trace
buffer, or a break in the execution of the application using a series of specific
conditions (events).
•
A Trace window to view the contents of the trace buffer, which permanently
records in real time on 32-bits:
-
Address and data bus information.
-
Flag status and 4 external signal values.
You can record up to 1024 executed cycles. Using trace filtering, you can filter
out only those cycles you wish to record in the trace buffer. You can equally
control which of the recorded cycles are displayed in the Trace window using
line filtering. Addresses, data, control/status bits and 4 user signals are
displayed using mnemonic and user symbols.
•
Internal synchronization signals can be output to either of two Trigger Outlets
on the front panel of the emulator (OUT1 or OUT2). This feature enables you to
count events using an external equipment, when optimizing software for
example, or to synchronize an oscilloscope when debugging hardware.
•
Hardware Events can be used to control the sending of signals to the trigger
outputs.
•
You can choose the output that you wish the signal to be sent to (i.e. either
OUT1 or OUT2).
•
A Hardware Test function that allows you to perform a number of hardware
tests on the Development Board, at your choosing. Refer to
Running the
Summary of Contents for HDS2 Series
Page 42: ...3 STVD7 ST7MDTU3 EMU2B Emulator User Manual 42 63...
Page 52: ...4 Emulator Features ST7MDTU3 EMU2B Emulator User Manual 52 63...
Page 56: ...Appendix A Troubleshooting ST7MDTU3 EMU2B Emulator User Manual 56 63...
Page 62: ...Product Support ST7MDTU3 EMU2B Emulator User Manual 62 63...
