ST 515 E, Operator'S Manual

Page: 97 / 328

EN - 10
It summarises the main interventions to
be made and the frequency applicable
to each of them. Carry out the relevant
intervention according to the first deadline.
• The use of non-genuine spare parts and
accessories could adversely affect machine
operation and safety. The manufacturer shall
decline all liability in the event of injuries
or damages caused by such parts.
• Genuine spare parts are supplied by
authorized assistance workshops and dealers.
IMPORTANT All the maintenance and
adjustment operations not described
herein must be carried out by your dealer
or Authorised Service Centre.
7.2 CLEANING
Carry out cleaning operations with the
machine switched off. Do not try to remove
snow from the discharge without firstly:
• Releasing the auger control..
• Turning off the motor.
Always clean the machine after use.
To clean the machine adhere to the
instructions provided below:
• Stop the motor
• Disconnect the electric cable from
the snow thrower and disconnect the
extension from the electrical mains.
• Cool the snow thrower.
• Clean the snow thrower internally
and externally with an adequate
brush and/or compressed air.
Never wash the snow thrower with
water, otherwise the electric device will be
damaged causing the risk of electrocution.
8. STORAGE
When you intend to put your machine away for
more than 30 days:
1. Clean the snow thrower thoroughly.
2. Check for any damage. If necessary,
see to the necessary repairs.
3. If the paintwork is damaged,
touch it up to prevent rust.
4. Protect any exposed metal surfaces from rust.
9. ASSISTANCE AND REPAIRS
This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can
be performed by the user. Any regulations
and maintenance operations not described
herein must be carried out by your Dealer
or Authorized Service Centre, which have
the necessary knowledge and equipment to
ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Operations carried out in an inadequate
structure or by unqualified people will make
all forms of warranty null and void, as well
as any obligations of the manufacturer.
Only authorized service workshops carry
out guaranteed repairs and maintenance.
• The authorized service workshops only use
genuine spare parts. Genuine spare parts and
accessories have been designed specifically for
machines.
• Non-genuine spare parts and accessories are
not approved. Use of non-genuine spare parts
and accessories cause the warranty to expire.
• It is advisable to send your machine once a year
to an authorized service workshop for servicing,
assistance and safety device inspection.
10. WARRANTY COVERAGE
The warranty covers all material and manufacturing
defects. The user must follow all the instructions
provided in the accompanying documentation.
The warranty does not cover damages caused by:
• Failure to become
familiar with the
documentation accompanying the machine.
• Carelessness.
• Incorrect or prohibited use or assembly.
• Use of non-genuine spare parts.
• Use of accessories not supplied or approved by
the manufacturer.
The warranty does not cover:
• Normal wear and tear of consumables, such as
drive belts, drills, headlights, wheels, bolts and
wires.
• Normal wear and tear.
• Motors. Motors are covered by the warranty
provided by the relative manufacturer in
compliance with the specified terms and
conditions.
The purchaser is protected by his own national
legislation. The purchaser’s rights envisaged by
the national laws in his own country are not in any
way restricted by this warranty.