ST 515 E, Operator'S Manual

Page: 93 / 328

EN - 6
with a plug which must be connected
to a 230 V c.a. current socket.
The electrical motor is activated by a starter lever
on the handle, activating the clearing auger. The
operator can drive the machine by holding it by the
handle where the starter lever is located, always
standing upright behind the machine.
3.1.1 Intended use
This machine has been designed and built to
remove and clear away snow from pavements,
gardens, drives and other ground-level surfaces.
The snow thrower must only be used to remove
snow.
3.1.2 Improper use
Any other usage not in keeping with the above-
mentioned ones may be hazardous and harm
persons and/or damage things. Examples of
improper use may include, but are not limited to:
• use of the machine on surfaces above ground
level, such as roofs on houses, garages,
porticoes or other structures or buildings.
• Activate the auger in the presence of materials
other than snow (e.g. soil, grass, pebbles, etc.),
• Pulling or pushing loads.
• Do not use the cable to transport the machine,
pull it or disconnect it from the socket.
• Do not carry passengers.
IMPORTANT Improper use of the
machine will invalidate the warranty, relieve
the Manufacturer from all liabilities, and the
user will consequently be liable for all and
any damage or injury to himself or others.
3.1.3 User types
This machine is intended for use by
consumers, i.e. non-professional operators.
The machine is intended for "DIY" use only.
IMPORTANT The machine must be used by
one operator.
3.2 SAFETY SIGNS
The machine has various symbols on it
(fig. 3). They are used to remind the operator
of the behaviour to follow to use it with
the necessary attention and caution.
Meaning of symbols:
DOUBLE INSULATED -
Class II:
Device in which protection against
electric shocks is not based exclusively
on the main insulation,but aIso
on additional safety measures such
as double or reinforced insulation.
These measures do not include
earthing devices and do not depend
on the installation conditions
WARNING! In the event of non-
compliance with regulations, the
risk of death and/or damage to
people or property exists.
Read the instructions before operating
the machine.
DANGER! Thrown objects. Do not turn
the discharge chute towards onlookers
or animals.
DANGER! Keep people, children and
animals away from the work area.
DANGER! Rotor turning. Always keep
away from the snow discharge opening.
DANGER! Keep hands and feet
away from rotating parts.
DANGER! Never put your hands inside
the discharge chute when the auger
is in motion. Stop the engine before
unclogging the discharge chute.
DANGER! Always use
hearing protectors
DANGER! Wear eye protection.
DANGER! Before carrying out
maintenance on the machine,
disconnect the plug from the socket.
IMPORTANT Any damaged or illegible
decals must be replaced. Order replacement
decals from an authorised assistance centre.
3.3 IDENTIFICATION LABEL
The identification label holds
the following data (fig. 1):
1. Manufacturer's address
2. Type of machine
3. Sound power level
4. CE conformity marking