Meter Setup
Detector Factor
[Factory Set]
A
The Detector Factor parameter is set at the factory. This factor compensates for accuracy error as a result
of the installed detector. If accuracy adjustment of the meter is required, please refer to the scale factor.
In the event the amplifier is replaced, this parameter must be reprogrammed with the original detector
factor.
Detector Offset
[Factory Set]
A
The Detector Offset parameter is set at the factory. This parameter compensates for accuracy error as a
result of the installed detector. If accuracy adjustment of the meter is required, please refer to the scale
factor.
Measurements
Flow Units
[GPM]
U
Flow Units lets you set the unit of measure for the flow rate and full scale flow. Changing the flow units
parameter readjusts the full scale flow parameter. For example, changing from gpm to gps would
change the full scale flow from 60 gpm to 1 gps.
To change the Flow Unit, follow these steps from the
Measurements
menu:
1. Select
Flow Units
to view the
Flow Units
display.
2. Position the arrow next to one of the following flow unit options:
Code
Flow Unit
Code
Flow Unit
LPS
Liter/Second
GPM
Gallons/Min
LPM
Liter/Minute
GPH
Gallons/Hour
LPH
Liter/Hour
MGD
MegaGallon/Day
M
3
S
Cubic Meter/Sec.
IGS
UKG/Sec.
M
3
M
Cubic Meter/Min
IGM
UKG/Min
M
3
H
Cubic Meter/Hour
IGH
UKG/Hour
F
3
S
Cubic Feet/Sec.
LbM
Pound/Min
F
3
M
Cubic Feet/Min
OPM
Ounce/Min
F
3
H
Cubic Feet/Hour
BPM
Barrel/Min
GPS
Gallons/Sec.
3. Press
[E]
to save the flow units and return to the
Measurements
menu.
Installation & Operation Manual
Page 31
March 2014
