55
Accelerator Damper™ Installation
Install the anchor tool onto the Accelerator Damper™.
Insert the anchor tool and Accelerator Damper into the carbon fiber upper
while simultaneously pulling the XLoc™ hose through the leg.
NOTICE
Make sure the wiper seal slides onto the tool without folding the outer lip of
the seal.
Tighten the anchor
counter-clockwise
.
The XLoc hose will spin as you tighten the anchor. This is normal.
Remove the anchor tool.
Clean the inside and outside of the stanchion
Install the Maxle Ultimate™ through the dropout. Thread the bottom cap into
the bottom of the stanchion.
Leverage the Maxle Ultimate against a bench top, then tighten
clockwise.
Anchor tool
3
4
30 mm
12 N·m (110 in-lb)
5
6
24 mm
12 N•m (110 in-lb)