35
Charger 2 Damper™ Installation
2 0 0 H o u r S e r v i c e
C h a r g e r 2 D a m p e r ™ I n s t a l l a t i o n
Install the Charger 2 Damper into carbon fiber upper until the lockout
extension shaft protrudes from the hole in the knob base.
Insert the anchor tool into the carbon fiber upper.
NOTICE
Make sure the wiper seal slides onto the tool without folding the outer lip of
the seal.
Tighten the anchor
counter-clockwise
. Remove the anchor tool from the
carbon fiber upper.
For easier installation, apply a thin layer of grease to the inside lip of the
anchor tool.
Clean the inside and outside of the stanchion
Slide the stanchion into the carbon fiber upper until it stops and the shaft is
visible through the bottom bolt hole.
1
2
Anchor tool
30 mm
12 N·m (110 in-lb)
3
4
