22
Carbon Fiber Upper Service
Position the fork horizontally in the bicycle stand.
Thread the anchor bolt into the air shaft.
For easier installation, apply a thin layer of grease to the hex wrench where
it contacts the anchor bolt.
NOTICE
Do not allow the bolt to fall off the hex wrench into the carbon fiber upper.
If the bolt falls off the hex wrench, remove the carbon fiber upper from the
bicycle stand and shake it to move the bolt close to the hole. Use a magnet
to help remove the bolt, and repeat the step.
Tighten the anchor bolt.
Install the access cover.
Refer to your pre-service recorded settings to pressurize your air spring, or
use the air chart on the fork's upper leg and pressurize the air spring.
You may see a drop in the indicated air pressure on the pump gauge while
filling the air spring; this is normal. Continue to fill the air spring to the
recommended air pressure.
200 Hour Service
Continue the 200 Hour Service for a
Charger 2 Damper™
.
200 Hour Service
Continue the 200 Hour Service for an
Accelerator Damper™
.
5mm, long hex bit socket
8
9
5 mm, long hex bit socket
8 N·m (70 in-lb)
10
11
