26
LCD Arm Mount Installation
¤
2005-2010 SR Research Ltd.
5.
LCD Arm Mount Installation
Please follow the steps below to set up the EyeLink 1000 LCD Arm Mount. Figure 5-1
illustrates a typical LCD Arm Mount setup and Figure 5-2 illustrates parts of the EyeLink 1000
LCD Arm Mount as it ships from SR Research under its standard configuration. The mount
first requires fixing the Arm Base to a sturdy tabletop, assembling the LCD Arm components,
attaching the EyeLink High-Speed Camera and then attaching cables. The following
instructions detail each of these procedures.
The contents of the Figure in clockwise direction, starting at the top, are: the Camera and LCD
Assembly, three Velcro strips (rolled and piled), cabling emerging from the end of the LCD Arm
(which runs diagonally throughout the photo), the Arm Base, two L-shaped Imperial Allen
wrenches, 2.5” and 6” extender tubes, the LCD Arm, and two angled brackets. Not shown in
the photo are pieces of the monitor that allow it to be used with a traditional monitor mount
should the user ever wish to remove it from the LCD Arm Mount for conventional use, the
monitor driver CD and instruction booklet, and extension cables (SVGA, audio and power).
Figure 5-1: Typical EyeLink 1000 LCD Arm Mount Installation
5.1
Choosing a Table
Before mounting the LCD Arm, and the Camera and LCD Assembly, the Arm Base (see Figure
5-2 and Figure 5-3) must be affixed to a sturdy table. The Arm Base can accommodate tables
with a thickness of up to 75 mm (7.5 cm, 2.5”) at a depth of 18 mm to 65 mm (1.8-65 cm,
