Data di emissione:
January, 2019
Revisione:
2
Pag. :
32/60
Once performed all these cleaning and
sanitizing procedures, it is possible to
reassemble all the components.
The correct assembly of the device is essential
to prevent leakage of product and damage of
the machine. To assemble the machine you will
need an approved lubricant (such as Vaseline).
Make sure all parts have been washed and
sanitized before assembling. Persons assembling
the machine must first wash and sanitize their
hands and forearms with an approved sanitizer.
- Mount the mixing system back together
(fig.14), according to the following procedures:
•
Spread the suction gaskets (X) with
Vaseline grease to reduce friction and
thus limit wear (fig.16).
•
Mount the bowl seal (T) making sure it
faces the right direction (fig.17).
•
Assemble the scraper auger (U), making
sure the head is perfectly engages with
the driving shaft.
•
Secure all the parts into place by
screwing the bolt (S) in a counter
clockwise direction.
- Mount the bowl back on, positioning it into
place, and making sure that it has a tight hold
on its gasket (see figure 18). To facilitate this
procedure, we also suggest that the rear part of
the bowl be lubricated at the point in which it
fits together with its sealing.
- Secure the bowl by tightening the two knobs,
without exerting excessive pressure.
IMPORTANT
Do not over tighten the bowl knobs.
Excessive force could damage the thread
and/or the bowl itself.
- Reassemble the parts of the dispensing tap,
making sure that the gaskets (J) are lubricated
with Vaseline grease so that the tap slides
smoothly back into its fixed position, until it’s
completely inserted (see figure 19).
!Important!
The not perfect sliding of the tap
compromises its own seal.
Fig. 16
Fig. 17
Fig. 18
Fig. 19
