Splendide WD2000S, Training Manual

Page: 16 / 72

Installation Information
10
by hand until they are seated on each gasket.
2. Attach the hose connected to the ‘H’ valve to the hot water
faucet. Screw on the coupling by hand until it is seated on the
gasket. DO NOT OVERTIGHTEN.
3. Attach the hose connected
to the ‘C’ valve to the cold
water faucet. Screw on the
coupling by hand until it is
seated on the gasket. DO
NOT OVERTIGHTEN.
4. Turn on the water faucets
and check for leaks.
Secure the Drain Hose
1. Drape the power cord over the washer top.
2. Secure the drain hose to the laundry tub leg or standpipe with a
strap or cable-tie.
3. Use the U-Clamp (provided) and insert the drain hose into the
standpipe or sink. DO NOT force excess drain hose into
the standpipe. There should be only 6” of drain hose
in the stand pipe.
Level the Washer-Dryer
Properly leveling the washer-dryer, prevents excessive noise and
vibration.
1. Tilt the machine back, leaning it
against the wall.
2. Adjust the legs up or down to
ensure the washer is resting
solid and does not rock side-to-
side or front-to back when the
machine is upright.
H
C
20" (50 cm) min.
with an air break
25" (62 cm) min.
34" (86 cm) max.
6" max.
Standpipe
U-Clamp
IMPORTANT!
Replace the inlet hoses after 5-years of use to reduce the risk
of hose failure. Record hose installation or replacement dates
on the hoses for future reference. Periodically inspect and
replace hoses if bulges, kinks, cuts, wear, or leaks are found.