Splendide WD2000S, Training Manual

Page: 43 / 72

Accessing the Components
37
Removing the Main Motor
After removing the back panel, remove the Drive Belt. Next, remove
the two 13mm mounting bolts that secure the motor to the tub.
(Fig. 4-25) Slide the motor and bracket out 1 inch from the tub. Be-
Removing the Back Panel
Remove the 7 Phillips screws that secure the panel to the back of
the cabinet. (Below) Now lift the panel off .
Back Panel / Main Motor / Module Board
The Main Motor and Module Board can be accessed once the back panel has been removed.
IMPORTANT!
When re-installing the Main Motor, it’s very important to
make sure that it’s properly re-seated and aligned, with the
rubber hanger on the right, rear-side of the motor. Check that
the wire ties are also replaced.
fore completely removing the motor assembly, use needle-nose
pliers to remove the two plastic wire ties from the bracket.
Removing the Module Board
Remove the two, size 15 Torx Head screws that secure the Module
Board to the case (below). To remove the board, swing the bottom
of the board out of the unit, then the top of the board.
IMPORTANT!
When reinstalling the Module Board, do not confuse the CNI
and CNF plug locations. (See “Connector Locations on the
Module Board). Also, pay close attention to the orientation
of the CNG plug. Make sure that the pins are on the top of the
CNG plug when the board is in the machine.