Splendide WD2000S, Training Manual

Page: 40 / 72

Accessing the Components
34
Removing the Heater Coil and Housing
The heater housing and coil come as one assembly. You cannot
remove the coil from the housing.
Carefully mark all the wires and remove them from the fan motor,
ECO’s, NTC sensor, and heater coil. Next, remove the two 13mm
nuts that secure the heater housing bracket to the counterweight.
(Fig. 4-20). Lift the duct straight up from the rear. Disconnect the
porthole diaphragm where it attaches to the front of the heater
housing using care not to damage the diaphragm.
IMPORTANT!
About Condenser Models
There are two gaskets on the heater housing
assembly. When reinstalling the assembly,
you must align these two gaskets with the
corresponding holes. (Fig. 4-21) After care-
fully aligning the gaskets with the holes, apply
downward pressure as you tighten the two nuts
that secure the heater housing bracket to the
counterweight. (Fig. 4-22) If the gaskets are not
seated correctly, the unit will leak.
IMPORTANT!
About Vented Models
Vented models have a rubber spacer on the
heater housing that assures clearance for ad-
equate airfl ow to the fan. Check that this spacer
is properly installed before reassembly.