Splendide WD2000S, Training Manual

Page: 34 / 72

Accessing the Components
28
Removing the Knobs
Remove the knob by pulling
straight out. If you need to use
pliers, make sure to use a shop
rag as a buff er, so the knob does
not get damaged. (Right)
Removing the Cycle Selector
Depress the tab at the top, center of the recessed area, then lift the
selector up and off the mounting brackets. (Fig. 4-3)
NOTE: Make sure that the wires on
the plug correspond to the contacts
on the tab of the Selector when re-
installed. (Right)
Required Tools
To access components in this washer-dryer, you’ll need Metric and Standard sockets of various sizes, Torx-15, 25 Drivers, a Flat Head Screw-
driver, and a Phillips Head Screwdriver.
Removing the Washer-Dryer Top
Two Phillips Head screws secure the main top at the back of the
washer-dryer. (Fig. 4-1) Remove these screws and lift straight up
on the rear of the main top.
NOTE: There is a green and yellow ground wire attached to the heat
shield on the main top. (Fig. 4-2) This wire will release as you remove the
top. Be sure to re-attach it when the top is re-installed.
Access to the Control Panel requires that the top of the washer be removed.
Top Panel / Control Panel Components