Spectrex SharpEye 40/40I, User Manual

Page: 41 / 85

TM 40/40I, Rev (14) February 2017
Connecting the Detector 41
Figure 7: Detector with Cover Removed
5
Connect the wires to the required terminals on the Terminal Board
according to the wiring diagram (Figure 7) and Table 15.
6
Connect the grounding (earth) wire to the ground (earth) screw outside
the detector (earth terminal). The detector must be well grounded to
earth ground.
7
Verify the wiring. Improper wiring may damage the detector.
8
Check the wires for secure mechanical connection and press them neatly
against the terminal to prevent them from interfering while closing the
back cover (Figure 7).
9
Place and secure the detector’s back cover by screwing the 3 socket-
head-screws in the cover bolts (Figure 4).
2.7.1 Verifying the Detector Wiring
The detector has 5 output wiring options within the Exde integral terminal
section of the enclosure. There are 12 terminals labeled 1
– 12.
For more information on the wiring options, see Wiring Instructions on
page 65.
Earth
Terminal
Terminal
Chamber
Terminals
Internal Earth
Terminal
Detector Holding
Screw
Conduit/Cable
Inlet
www.acornfiresecurity.com
www.acornfiresecurity.com