Spectralink 80-Series Handsets Administration Guide with SRP
1725-86030-000_G.docx
October 2013
28
Admin Tip
The speakerphone option must be programmed in the Spectralink 80-Series
Telephony Gateway for it to function as an off-hook softkey option. See
Spectralink
80-Series Telephony Gateway: Administration Guide for SRP
for more information.
If the speakerphone is disabled in the
Admin
menu, the
Spkr
softkey will not appear
during standby. However, if it has been programmed in the Spectralink 80-Series
Telephony Gateway, the
Spkr
softkey will appear during active mode but it will be
non-functional.
Location Service
Location service may be used to enable or disable the Ekahau Real-Time Location System
(RTLS), select a transmit interval, or enter a static IP address for the Ekahau Positioning Engine
(EPE). Location services capability is provided by the EPE 4.0 using Ekahau Location Protocol
(ELP). See Ekahau’s user documentation for more information.
RTLS [Enable/Disable]
The RTLS is disabled by default. Press
NavOK
to toggle to the
alternate setting. When RTLS is enabled, the handset will display the RTLS icon
in the top
center of the screen.
The ring indicator icon will take precedence over the RTLS icon, i.e. the new icon will not be
visible while the handset is ringing. When ringing has ceased and the ring indicator becomes
inactive, the RTLS icon will again appear (regardless of hook state).
Transmit interval
Allows selection of
1 minute
,
5 minutes
, or
10 minutes
for maximum time
between transmit intervals. Default transmit interval is 10 minutes. Press
NavOK
to select the
desired transmit interval.
Troubleshooting
o optimize battery life, the interval between sending out ELP updates will vary based
on handset state. It is expected that ELP updates will occur at most every two to six
seconds and at least every few minutes. If improved tracking capability is desired, set
the transmit interval for a shorter time between ELP updates. Increasing the
frequency of transmissions will decrease battery life.
Location Server IP
Allows the user to statically enter the IP address of the EPE. Enter the IP
address and press
NavOK
to save.
Settings
Ekahau clients are not expected to find the EPE automatically. Regardless of the
handset’s selection of DHCP or static IP, the EPE IP address must be statically
entered in the Ekahau admin menus or HAT.
