1725-86030-000_G.docx
October 2013
20
Chapter 3:
Spectralink 80-Series Handset
Configuration
Prior to configuring a Spectralink 80-Series Handset, it must be associated with one and only
one line on one of the Spectralink 80-Series Telephony Gateways. Then it must be configured
per the instructions in this section. The following instructions assume that the handset has been
properly associated with a line on a Spectralink 80-Series Telephony Gateway. See
Spectralink
80-Series Telephony Gateway: Administration Guide for SRP
for additional information. While
handsets are being associated, the system will continue normal operation.
Use the
Wireless Device Planning Worksheets
filled out by the network or system administrator
to be sure you are correctly assigning telephone parameters.
The Spectralink Handset Administration Tool is a software utility that enables rapid configuration
of handsets by utilizing the USB port on the Dual Charger. See the
Handset Administration Tool
document for specific instructions. Please see your service representative or contact Spectralink
customer service for more information about this time-saving tool.
When WPA2 Enterprise security is used, PAC files for EAP-FAST can be provisioned wirelessly
or by using the HAT. For PEAP, the HAT must be used to enroll certificates. See below for
details.
Other settings that must be configured include, but are not limited to, WLAN QoS, DSCP
tagging, DHCP and regulatory domain information. If these are not selected by the
administrator the handset will use the default settings.
The Admin Menu
The
Admin
menu contains configuration options that are stored locally (on each handset).
Every handset is independently configured and if the default settings are not desired, the
Admin
menu options must be set in each handset requiring different settings.
Opening the Admin menu
1
With the handset powered off, press and hold the
START
key. While holding the
START
key, press and release the
END
key.
2
When the
Admin
menu appears, release the
START
key.
