31
Inlet Service Port
Outlet Service Port
Dry Testing With Artificial Ocean
If it is not possible to test run the system with the boat in the water testing may be accomplished with
an artificial ocean. Purchase enough aquarium salts to make 5 gallons (20 liters) of salt water.
Make sure that the domestic water system is pressurized and that there is at least 30 gallons (120 li-
ters) of water in the tank. Confirm that the Charcoal filter is installed in the Fresh water flush module
and that the domestic water line had been installed and all valves are open.
1.
O
O
O
Op
p
p
pe
ee
en
n
n
n P
P
P
Prrrre
ee
essssssssu
u
u
urrrre
ee
e R
R
R
Re
ee
elllliiiie
ee
effff V
V
V
Va
aa
allllvvvve
ee
e
.
2. Power up the control system.
3.
Press both “A
A
A
Au
u
u
utttto
o
o
o R
R
R
Ru
u
u
un
n
n
n” and “S
S
S
Stttto
o
o
op
p
p
p”
to bypass the purge sequence. If the motor starts, press
stop, then press the Auto run and stop buttons again. Keep trying until you get a message
PURGE MODE BYPASSED.
4.
Press the Auto Store button
and allow the fresh water flush system to cycle through its
timed operation.
Cycle the auto store system 5 more times
to purge all of the storage
chemicals out of the system.
5.
Hook up your service hoses
per the service diagram and photos. Route them into a 5 gallon
(20 Liter) bucket. Disconnect the product tube from the diversion valve and using another short
piece of tube route the product water feed into the test bucket.
6.
Turn the service valve
on the fresh water flush module from “
Run”
to
“Service.
”
7.
Press auto flush
one or two more times to get enough water into the bucket to properly mix
your salt water. Mix the salt until it goes into solution. If you are using a hydrometer mix the wa-
ter to be 32,000 PPM.
Close the pressure relief valve
and
start the system
using the
“
Auto Run”
Button.
8. Run and test the system for as long as possible. During the test run carefully inspect for leaks.
Check all of the system parameters to make sure the system is operating correctly. Do not allow
the water in the bucket to get above 120F (50C). The water in the “artificial ocean” will begin to
disappear as it becomes fresh and goes to the water tank. If a longer test is needed divert the
product water back into the Artificial ocean.
9. Store the system by following the “Automatic Fresh Water Flush Cycle,” “Long Term Storage
Procedures”, or “Storage and Winterizing” instructions..
Artificial
Ocean
Disconnect
Summary of Contents for Newport 1000
