Digital Video Recorder
43
Highlight the box beside
Type
and press the
button. You can select the type of network configuration from:
Manual
,
DHCP
and
ADSL (with PPPoE)
. Select the desired type and press the
button.
Selecting
Manual
from the Type allows you to set up LAN parameters manually.
Change the numbers by highlighting them and using the
Up
and
Down
arrow buttons to increase or decrease the number.
The factory default LAN settings are:
IP
Address: 192.168.1.129
Gateway:
192.168.1.254
Subnet
Mask:
255.255.255.0
NOTE: You will need to get the appropriate IP Address, Gateway and Subnet Mask from your network
administrator.
Highlight the box beside
DNS Server
. Press the
Up
and
Down
arrow buttons to set the IP address of the DNS server.
Highlight the
Port Number Setup…
box and press the
button. The
Port Number Setup
screen appears.
NOTE: You will need to get the appropriate Port Numbers for each Speco Central II and Speco Remote related
program (Admin, Callback, Watch and Search) from your network administrator.
Change the numbers by highlighting them and using the
Up
and
Down
arrow buttons to increase or decrease the number. The factory default
Port settings are:
Remote Admin: 8200
Remote Callback: 8205
Remote Watch: 8201
Remote Search: 8202
NOTE: The system restarts automatically after changing the port settings.
Do NOT use the same port number for two different programs, otherwise, the DVR cannot be connected
with the PC running Speco Central II or Speco Remote.
CAUTION: When changing the port settings, you must change the port settings on the PC running
Speco Central II as well. Refer to the Speco Central II manual for details.
Highlight
Use UPnP
and press the
button to toggle between On and Off. When it is On, port forwarding from the
NAT (Network Address Translation) device to the DVR will be enabled automatically via UPnP (Universal Plug and
Play) service. This function will be especially useful when accessing a port on a private IP address.
NOTE: For the UPnP service to work, the NAT device should support the UPnP Port Forwarding function and
the function should be set to enabled.
You cannot change the port settings when
Use UPnP
is On.
Highlight the
Status
box and press the
button to display the port numbers forwarded from the NAT device via UPnP
service.
Highlight the
Test
box and press the
button to test the current LAN settings you made.
