Sparky Group TV 1835, Original Instructions Manual

Page: 15 / 151

13
Original instructions EN
has to be done by the manufacturer or his agent in order
to avoid a safety hazard.
BRUSH REPLACEMENT
When the carbon brushes are worn out, both brushes
must be replaced simultaneously with genuine brushes
at SPARKY service centre for warranty and post-war-
ranty service.
CLEANING
For safe operation always keep the machine and its ven-
tilation slots clean.
Regularly check to see if any dust or foreign matter has
entered the ventilation slots and the grills around the
switches. Use a soft brush and/or air jet to remove any
accumulated dust. Wear safety glasses to protect your
eyes whilst cleaning.
Exterior plastic parts may be cleaned with a damp cloth
and mild detergent if necessary.
WARNING:
Never use alcohol, petrol or other
cleaning agent. Never use caustic agents to clean
plastic parts.
WARNING:
Water must never come into con-
tact with the tool.
IMPORTANT!
To assure product safety and reliability,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by
SPARKY certiied service centres, always using genu-
ine replacement parts.
Warranty
The guarantee period for SPARKY power tools is deter
-
mined in the guarantee card.
Faults due to normal wear, overloading or improper han-
dling will be excluded from the guarantee.
Faults due to defective materials implemented as well as
defects in workmanship will be corrected free of charge
through replacement or repair.
The complaints for defective SPARKY power tools will
be recognized if the machine is sent back to the dealer
or is presented to the authorised warranty service centre
undismantled, in its initial condition.
Notes
Carefully read the entire Original Instructions before us
-
ing this product.
The manufacturer reserves the right to make changes
and improvements to the products and to alter speciica-
tions without prior notice.
Speciications may differ from country to country.
TROUBLESHOOTING
Problem Probable cause Corrective action
Motor does not run.
No supply power.
Check the power supply, connect the
machine to another power outlet.
Faulty cable or plug .
Take the machine to an authorized service
centre.
Worn carbon brushes.
Take the machine to an authorized service
centre.
Other electrical fault.
Take the machine to an authorized service
centre.
Chain saw does not operate at full
capacity. . Extension cord is too long or its cross
section is too small. Use an extension cord with proper length and
cross section.
Power supply voltage (e.g. generator) is
too low.
Connect the chain saw to another power
outlet.
Poor cutting performance. Improperly tensioned chain. Tension the chain properly.
Worn-out (dull) chain.
Sharpen the chain or replace it.
Chain / guide bar overheats.
There is no oil in tank.
Reill oil.
Oil cap vents are clogged. Clean the cap vents.
Oil passage clogged. Clean oil passage outlet.
Chain is over-tensioned.
Tension chain properly.
Worn-out (dull) chain.
Sharpen the chain or replace it.