Note: When making network changes (Port Configuration, Ethernet On/Off, IP addresses, etc.), allow time for the changes to take
place. This can take a minute or two.
A20-Nexus Name
Tap to enter a unique name for the A20-Nexus. The A20-DX Name is used as the Dante Device name in a Dante network and the
network device name in a Control network.
The factory default A20-Nexus Name is A20-Nexus-[last 6 characters of the MAC address]
●
Warning:
Changing the A20-Nexus Name will cause the Nexus to disconnect from the Network for about a minute.
Ethernet On/Off
Enables/disables all ethernet ports. Disable Ethernet when not in use to reduce power consumption.
●
When the Ethernet switch is off the Port configuration button is grayed out.
●
When selecting a new port configuration, the following popup message appears: "Are you sure you want to change the
port configuration? OK, Cancel."
Dante and Control IP Settings
A20-Nexus supports both DHCP and static IP address setup. Dante and Control can be independently configured for DHCP or static
IPs.
●
When set to DHCP and connected to a DHCP server, Nexus automatically configures its IP address, subnet mask and
gateway.
●
When DHCP is Off, the Edit button is accessible. Tap the Edit button to edit the static IP address, subnet mask and
gateway fields. Tapping each field brings up the virtual keyboard. Hit Set to apply the settings.
A20-Nexus
User Guide
41
