Xantech Micro Link 490D Series, Installation Instructions

Page: 1 / 4

MODEL
49095D
Micro Link™ Peep-Hole Style
Plasma Proof IR Receiver
INSTALLATION INSTRUCTIONS
DESCRIPTION
The Micro Link IR Receiver is a small peep-hole style infrared repeater
assembly. The Micro Link IR Receiver is equipped with a 7-foot cable and a
3.5mm stereo mini plug, which is plugged directly into the “IR RCVR” jack on
the connecting block, such as the models 789-44, CB60, and 791-44. The
Micro Link IR Receiver is primarily intended for use in installations where the
connecting block is within reach of its 7-foot cable – as when installing the
Micro Link IR Receiver in a cabinet where the controlled equipment is behind
closed doors.
FEATURES
•
Small size; mounts in ¾ diameter hole. 2-3/4 inches deep (70mm).
•
Quick-Connect 3.5mm Stereo Mini Plug on 7ft. cable for direct plug-in to
Xantech Connecting Blocks.
•
Works in normal 3-wire mode (12VDC, IR, GND).
•
Green Talkback LED for System Verification.
•
Red talkback LED for system verification.
SPECIFICATIONS
•
Infrared modulation frequency bandwidth: 30 – 100 kHz.
•
IR reception range: > 55 feet.
•
Reception angle: 55 degrees off axis for 50% range reduction.
•
Cable requirements: 3-conductor. Use 24 gauge up to 200’, 22 gauge up
to 600’ 20 gauge up to 2000’, 18 gauge up to 5000’ – unshielded OK.
•
Max. transmission length: 1 mile using 18 gauge wire.
•
Maximum current output: 100mA
•
Drives IR emitters through Xantech Connecting Blocks, Controllers, etc.
•
Dimensions: 3/4” diameter x 2.75” deep (19mm x 70mm).
•
Power requirements: +12VDC, 20mA.
INSTALLATION
QUICK-START
A typical system will use an IR receiver, several emitters, and a power supply
all connected to a connecting block.
1. Connect the IR receiver to the “IR RCVR” port on the connecting
block. The ‘red’ connector is installed to the ‘red’ plug.
Note: In some extended distances, additional 3-conductor may be required and can
be connected to the terminals on the connecting block.
2. Connect the Emitters to the connecting block. The ‘yellow’ connector
is installed to the ‘yellow’ plug.
3. Connect the power supply to the connecting block.
4. Installation
complete
MOUNTING
Drill a 3/4” hole in any surface, such as a cabinet panel. Pass the lead and
the body of the 490 through the hole and secure from the rear with the nut
(supplied).
PLACEMENT
The IR receiver should be located so that it is not directly facing a light
source such as lamps or displays (standard, LCD, and Plasma). When
mounted near a display, it should be flush to the display and away from light
reflections that may occur.
LOCAL SYSTEM APPLICATION
In this system a 283D Blink-IR Designer Emitter is shown connected to the
“OUT” jack. If expansion beyond two emitters is required, use a Xantech 789-
44, CB60, or 791-44 Connecting Block.