55
Chapter 4 Operating the AIT Library
Raise the cartridge about 1 mm and pull it out.
8
If you selected “1. Single Mode” in
step 4, press the [CANCEL] button.
Note
Even if you selected “1. Single
Mode” in step 4, you can remove a
different cartridge by using the
V
and
v
buttons to select the slot
element address, and then pressing
the [ENTER] button. Because you
did not select “2. Multiple Mode” in
step 4, the cartridge dock shutter
closes and reopens. When it does,
you can remove another cartridge as
explained above. If you do so, when
you are done removing cartridges
press the [CANCEL] button and
proceed to step 10.
9
If you selected “2. Multiple Mode” in step 4, perform the following
depending on the number of inserted cartridges.
Two or more inserted
cartridges
The element address of the front
slot appears on the first line. The
element address of the next slot
appears on the second line.
1
Eject the cartridge and press the
[ENTER] button.
2
The slot moves to the next. Eject
the cartridge in the same manner
and press the [ENTER] button.
When you press the [ENTER]
button, the slot moves to the next.
3
Repeat until all the cartridges are
ejected, and then press the
[CANCEL] button.
Slot 01
Eject Tape
[CANCEL] to exit
Eject Tape Slot 01
Next Slot 02
[CANCEL] to exit
[ENTER] to next slot
