28
Chapter 2 Installation
8
If you selected “1. Single Mode” in
step 4, press the [CANCEL] button.
Note
Even if you selected “1. Single
Mode” in step 4, you can insert a
different cartridge by using the
V
and
v
buttons to select the slot
element address, and then pressing
the [ENTER] button. Because you
did not select “2. Multiple Mode” in
step 4, the cartridge dock shutter
closes and reopens. When it does,
you can insert another cartridge as
explained above. If you do so, when
you are done inserting cartridges
press the [CANCEL] button and
proceed to step 10.
9
If you selected “2. Multiple Mode” in step 4, perform the following
depending on the number of open slots.
Two or more open slots
The slot moves to the next one.
When it stops, insert another
cartridge and press the [ENTER]
button again. Repeat until all the
cartridges are inserted, then press
the [CANCEL] button.
1
Insert a cartridge and press the
[ENTER] button.
2
The slot moves to the next. Insert
another cartridge in the same
manner and press the [ENTER]
button.
When you press the [ENTER]
button, the slot moves to the next.
3
Repeat until all the cartridges are
inserted, and then press the
[CANCEL] button.
Only one open slot
The element address of the front
slot appears on the first line.
(Nothing appears on the second
line.)
1
Insert a cartridge and press the
[CANCEL] button.
Caution
Do not put your fingers in the slot when it is moving, as this could result in
injuries.
Slot 01
Insert Tape
[CANCEL] to exit
Insert Tape Slot 01
Next Slot 02
[CANCEL] to exit
[ENTER] to next slot
Insert Tape Slot 01
[CANCEL] to exit
