21
Chapter 2 Installation
Notes
• The date and time cannot be updated when the AIT library is off. For this
reason we recommend that you set the date and time each time you turn
on the library.
• If the library is left idle for five minutes, the status display appears
automatically.
3
After pressing the standby switch on the library's front panel, wait at least
10 seconds before turning on the host computer.
When using DHCP, wait at least 30 seconds.
Then, go to “Initial Setup” (page 22).
Notes
• If you start the host computer before the library, the SCSI ID is not
detected correctly. Therefore, always start the library before starting the
host computer.
• If the library does not work as above, refer to “Troubleshooting” (page
Turn the Power Off
Before turning off the library, perform the system shutdown procedure from the
control panel. After you have performed the procedure, you can turn off the
library.
1
At the status display, press the [MENU] button for two seconds.
2
Use the
V
and
v
buttons to select
“9. System Down,” then press the
[ENTER] button.
3
Select “2. Shutdown,” then press
the [ENTER] button.
4
When “[ENTER] to activate”
appears, press the [ENTER] button.
The system performs the shutdown
procedure.
5
When the message on the right
appears, turn off the library by
pressing the power switch on the
rear.
Caution
• Even though pressing the rear power switch can turn off the library power,
following the above steps is recommended.
Menu 12:34
7.Tape Inventory
8.Password
9.System Down
System Down 12:34
1.Reset
2.Shutdown
Shutdown
[ENTER] to activate
Shutdown
*** Wait a minute ***
Ready for shutdown
Press the power
switch on the rear
of the Library
