TEST UNIT READY
6.Command Specification
SONY AIT-3 drive SDX-700 series Ver.2.1
6-105
6.27.
TEST UNIT READY 00h
Bit
Byte
7 6 5 4 3 2 1 0
0
Operation Code (00h)
1
Logical Unit Number
Reserved
2
Reserved
3
Reserved
4
Reserved
5
Unused (00b)
Reserved
Flag
Link
TEST UNIT READY checks if the drive is ready. This is not a request for a self-test. If the drive has a tape loaded,
this command will return a GOOD status. Otherwise, CHECK CONDITION will be reported and the sense key will be
NOT READY.
Table 6-78: TEST UNIT READY results
Drive Status
Sense Key
ASC/ASCQ Description
Tape Loaded
No Tape Present
Tape Loading
Tape Unloading
Tape Unloaded (but retained in drive)
00 No Sense
02 Not Ready
02 Not Ready
02 Not Ready
02 Not Ready
00 NO ADDITIONAL SENSE INFORMATION
3A 00 MEDIUM NOT PRESENT
04 01 LOGICAL UNIT IS BECOMING READY
04 00 LOGICAL UNIT NOT READY
04 00 LOGICAL UNIT NOT READY
Summary of Contents for SDX-700C
