SonoSite C1.9 PLUS, Service Manual

Page: 29 / 98

Chapter 4: Setup and Operation 21
C
HAPTER
4
Setup and Operation
WARNING :
`
CRITICAL TEST FUNCTION - Skipping the functional tests in this procedure
could adversely affect safety or effectiveness of the system.
Operation of the SonoSite ultrasound system can be found in the user guide provided
with each system.
4.1 Connecting and Removing Transducers
The system comes with one or more transducers. Only one transducer can be
connected to the system at a time.
WARNING:
`
The transducer connector can become hot during operation. This is normal.
Operate the system in the SiteStand mobile docking station or on a flat, hard
surface to allow air flow past the connector.
CAUTION:
`
The electrical contacts inside the system transducer connector may be damaged by
foreign material or by rough handling. Do not touch the electrical contacts. Keep
foreign material out of the connector. Keep a transducer connected to the system
whenever possible.
To connect the transducer:
1. On the transducer connector, pull the latch up and rotate it clockwise until it
snaps to a stop (Figure 4.1). The latch should be easy to move. Do not force the
latch.
2. Align the transducer connector with the connector on the rear of the system and
insert it by pushing the transducer connector into the system connector. The
transducer connector should be easy to insert. Do not force the transducer
connector.
3. Turn the latch counterclockwise until it snaps to a stop.