14
EN
steps
Presenting the remote control
•
Affixing the label to the electronic unit
•
Switching the installation on
•
Programming the gate travel
•
Presenting the remote controls
►
The remote controls supplied in the kit (Keytis NS 2
RTS) are already memorised.
Button 1
on the remote controls activates the
opening of the gate.
Affixing the label to the electronic unit
►
The label (19) should be affixed to the motor's electronic unit (3).
switching the installation on
►
Switch the installation on.
The STATUS indicator
on the electronic unit will flash (2 pulses) to indicate that the
motors are on and awaiting setting.
If the STATUS indicator stays out, see page 30.
Programming the gate travel
►
The motor's electronics automatically store:
The motor torque required to control the gate, in normal operation. Once this is
•
stored, this enables any abnormal motor effort to be detected.
The travel distances required to fully open and close the gate with the positions of the end
•
stops.
During programming, you should remain at a normal distance from the gate and follow the
steps below:
4. Quick commissioNiNg
Press button 1
on the remote control
to initiate a comPlETE opening/closing
motion of the gate.
The sTaTus indicator
of the electronic
unit must be coNTiNuously liT.
If the STATUS indicator
is flashing, refer to
the troubleshooting section on page 30.
The gate movements must not be interrupted
(complete opening/closing).
If they are interrupted, programming will resume the
next time the opening command is made.
1
2
button 1
button 2