9
EN
mounting the motor
►
[1].
Tighten the 4 nuts (8) and add 4 washers (9).
[2].
Remove the cover (1) from the motor (4).
[3].
Position the motor on the
lag screws: ensure that
the bracket (base of the
motor) is no more than
25 mm above the ground.
The recommended space is
between 20 and 25 mm.
Use a spirit level to
check that the motor is level.
[4].
Once the motor is positioned at the right height
in relation to the ground, fix it in place using the
washers (9) and tighten the 4 nuts (8).
[5].
Position the pre-drilled grommet (10) in the
opening through which the supply cable
should be fed.
steps
Fitting the lag screws
•
Mounting the motor
•
Fitting the rack
•
Mechanical adjustment
•
fitting the lag screws
►
[1].
Position the installation template (18) on the
ground and drill 4 holes using a drill bit (Ø
12 mm) suitable for the type of ground.
[2].
Insert the plugs (12). Screw in the lag
screws (11).
2. mouNTiNg
grease the lag screws lightly before
screwing them into the plugs.
