17
System 3 (Figures 23, 24 and 25)
1- Placing the module (A) in the desired location and position the stove in the top of the same
ensure that the side and the front of the stove are aligned with the side and the front of the module;
2- Using the screw (B), washer (C) and security support (D) included in the kit, connect the module
to the stove through the existing hole in the top of the module and at the bottom of the stove;
3 - Fixing (D) must get into the groove of the stove and the module, slide laterally between the two
components. Then use the screw and washer supplied, tighten the clip to the stove in the nut
welded to the bottom of it;
Fig. 21 – Fixing System 1
Fig. 22 – Fixing System 2
Summary of Contents for TEK Basic
