15
Versions Tek Unit, Roll, System, Corner, Wall and Lumber
For versions listed above, this system has to be purchased separately. For installation shall:
1 - Access the back of the computer and remove the back cover (A), in cases where it is applied;
2 - Place the outside air kit (C) in the oven, using the nuts supplied with the kit;
3 - Breaking the micro-connections at the bottom (B) of the cover (A) or in the outer casing of the
equipment;
4 - Replace the cover (A) on the stove;
5 - Using this accessory as a point of connection to the outside ambient air by installing the
appropriate pipe for this purpose.
(A)
(A)
(A)
Fig. 18 – Rear view of each model; (A) Section to remove for external air inlet
Fig. 19 – Removing section (B) for placement external air inlet (C)
Summary of Contents for TEK Basic
