14
TEK Round model:
1-
Release the external cover from the rear of the unit by unfastening the 4 screws.
Next, lift up the cover, releasing it from the supporting props on the back of the unit;
2-
Remove the fume baffle (as described in section 9.2 under the "Cleaning and
Maintenance" chapter) taking care not to damage any of the vermiculite plates;
3-
On the rear cover of the stove (previously removed), open the section corresponding
to the horizontal fume outlet. To do this, use cutting pliers to cut off the mini-joints that
secure this section to the external casing of the unit;
4-
In the inner roof of the combustion chamber, unfasten the 6 screws using a socket
head hex wrench to release the fume outlet;
5-
Place the fume outlet in a horizontal position;
6-
Refasten the screws to the inner roof of the chamber to secure the fume outlet in the
horizontal position;
7-
Replace the fume baffle by following the steps above in reverse order;
8-
Reattach the rear cover by fitting the lower wedges into the grooves at the bottom of
the unit. Next, refasten the 4 screws you previously removed;
9-
Using the additional cover provided, block the section left open on the top of the unit
resulting from the repositioning of the fume outlet.
3.2.2 - Connecting the external air inlet
If you wish to use the external air inlet, please follow these steps:
1-
Open the door of the unit, to facilitate the operation;
2-
Unfasten the screws from the front embellisher plate, taking care not to scratch it;
3-
On the rear side of the unit, detach the appropriate section to install the external air
inlet (see Fig. 18); To do this, use cutting pliers to cut off the mini-joints that secure
this section to the casing of the unit;
4-
Direct the pipe to be used as exterior air intake by sliding it through the rear casing
and connect it directly to the air inlet nozzle. Use a metallic bracket to secure the air
pipe and ensure perfect sealing;
5-
Replace the front embellisher plate in its proper position and tighten the retaining
screws.
Summary of Contents for TEK Basic
