31
* The cable used for the electrical connection should be silicon-coated and heat-resistant
to 356°F (180°C). If the power feed cable is damaged, it should only be replaced by a
qualified technician;
*
You should take care to not lay the cable where it may be crushed
;
* The electrical installation should incorporate means to switch the unit off, with a minimum
separation of 0.118 inches (3mm) between the contacts, pursuant to the applicable
legislation in force.
1
9. Safety
* Please note that the exposed metallic parts of the unit reach very high temperatures
– 100°C on
the door and 60°C along the external casing. The door latch
does not
heat beyond 45°C, but
avoid any contact with other parts that may be hot;
* If any contact with the unit is necessary while it is in operation, remember to use a glove or other
form of protection;
* In case of
fire
in the
chimney
,
immediately close
the
door of the unit, as well as the primary
and secondary air inlets
;
* We recommend that you use only spare parts supplied by the manufacturer
– (SOLZAIMA).
10. Cleaning and Maintenance
10.1. Cleaning
- Ash build up should be regularly removed from the chamber (but only after turning off the
unit and allowing it to cool down);
- The glass should always be cleaned with an appropriate product
2
, following the
instructions for use and avoiding any contact of the cleaning product with the window rope gasket
OR any painted metal parts,
– which can lead to oxidation. To ensure this, only apply the cleaning
product on a cloth, never directly on the glass. The rope gasket is glued on to the glass, so do not
expose it to the direct contact with water or any other liquids. If the rope gasket eventually
becomes unglued, you can reattach it using high temperature silicone sealant or refractory glue,
but only after having carefully cleaned the groove using fine sandpaper;
1
We recommend the use of a 30 mA differential switch and a 0.5 A circuit breaker for the unit’s electrical installation.
2
For more information, contact the unit's installer.
Summary of Contents for TEK Basic
