SOLZAIMA Everest, Instruction Manual

Page: 15 / 171

10
•
If you do not opt for a chimney with smoke outlet coaxial (see section 9.5 of this
manual) the air inlet must be protected by a grid made in anti-insect mesh or similar
product, provided that they do not reduce the air intake section.
• In the case of pellet stove Everest, being a stove, does not consume oxygen from
inside the housing, collecting this outdoor environment; when connected to the air
intake tube to the outside, this stove may be placed in insulated houses, the so-called
passive houses.
Important note: the tubes or couplings to be used should contain elements of fence
to ensure a good seal.
9. Installing the smoke ducts in a pellet stove
Before starting the installation, perform the following actions:
• Remove the instruction manual from the package, read it carefully and upon
completing the installation procedure hand it over to the client.
• Check the product for completeness and to determine that it does not show any
signs of damage. Any damages or defects should be checked before the equipment is
installed.
• This pellets stove is equipped with four adjustable height feet at the base, allowing
for easy regulation when installing the equipment on a non-levelled surface.
Figure 5 - Adjusting the free-standing pellet fire unit
•
Connect an 80 mm in diameter between the outlet of the combustion gases and a
smoke exhaust duct to the exterior of the building (e.g., chimney) – check schemas in
the point 9 of this manual.