Sole Diesel 10 GSC, Operator'S Manual

Page: 6 / 120

5
Rev. 3
TABLE OF FIGURES
Fig. 1. Warning label. In case of fire 7
Fig. 2. Warning label. General precautions 8
Fig. 3. Warning label. Rotating parts 8
Fig. 4. Warning. Carbon monoxide 9
Fig. 5. Warning. Battery charging 9
Fig. 6. Warning. Hot engine 9
Fig. 7. Caution label. Overcrank consequences 9
Fig. 8. Caution label. Not a step 10
Fig. 9. Nameplate location 12
Fig. 10. Genset nameplate 12
Fig. 11. Packed genset 19
Fig. 12. 8 GTC / 10 GTAC / 7 GSC / 8 GSAC lifting eyebolts 20
Fig. 13. 11 GTC / 14 GTAC / 10 GSC / 12 GSAC / 17 GTC / 20 GTAC / 14 GSC / 17 GSAC lifting
eyebolts 20
Fig. 14. Genset controller 24
Fig. 15. Genset covers 27
Fig. 16. Location of genset elements 8 GTC / 10 GTAC / 7 GSC / 8 GSAC 28
Fig. 17. Location of genset elements 11 GTC / 14 GTAC / 10 GSC / 12 GSAC / 17 GTC / 20 GTAC /
14 GSC / 17 GSAC 29
Fig. 18. Maintenance kit 32
Fig. 19. Valve clearance inspection 33
Fig. 20. Valve clearance adjust 33
Fig. 21. Compression pressure inspection 33
Fig. 22. Lubrication circuit 34
Fig. 24. Solé Diesel oil SAE 15W40 35
Fig. 25. Modification of oil dipstick for inclined operation 36
Fig. 26. Oil filter change 37
Fig. 27. Fuel circuit 37
Fig. 28. Fuel filter change 38
Fig. 29. Water separator filter change 38
Fig. 29. Remove injector 39
Fig. 31. Test injection pressure 39
Fig. 32. Adjust injection pressure 39
Fig. 33. Shape of injector discharge 39
Fig. 34. Tip and nozzle of injector 40
Fig. 36. Coolant circuit 41
Fig. 37. Seawater circuit 41
Fig. 38. Coolant drain plugs 42
Fig. 39. Refill coolant circuit 42
Fig. 40. Seawater filter 43
Fig. 41. Seawater pump impeller inspection 43
Fig. 43. Installation type 1 when between water injection point of wet exhaust and waterline is
minimum 150 mm 44
Fig. 44. Installation type 2 when between water injection point of wet exhaust and waterline
there is less than 150 mm or the point of injection is below waterline 45
Fig. 45. Air filter inspection 45
Fig. 46. Genset panel 46
Fig. 47. Incandescent glow plug inspection 47
Fig. 48. Glow plug behavior 48
Fig. 49. Starter motor inspection 48
Fig. 50. Alternator belt tension inspection 48