Sole Diesel 10 GSC, Operator'S Manual

Page: 33 / 120

32
5.3 General
Solé Diesel offers, for these genset
models, a maintenance kit, which includes:
Oil filter
Diesel filter
Impeller
Raw water pump gasket
Fig. 18. Maintenance kit
MAINTENANCE TASK. SCREW TIGHTENING, FASTENING
For details of tightening torques see Annex 7.6.
MAINTENANCE TASK. VALVE CLEARANCE INSPECTION
The rocker cover must be dismounted to check the valve clearance. This operation must be
carried out when the engine is cold.
Item Assembly Standard
Valve clearance (cold setting)
Inlet
0,25 mm
Exhaust
Table 6. Valve clearance
INSPECTION
1. Inspect the valve clearance in the injection sequence. To check, turn the crankshaft by the
specified crank angle in the normal direction to bring the piston to the top dead center of the
compression stroke.
Injection sequence
Crank angle
8 GTC / 10 GTAC / 7 GSC / 8 GSAC /
11 GTC / 14 GTAC / 10 GSC / 12 GSAC
1 – 3 – 2 240º
17 GTC / 20 GTAC / 14 GSC / 17 GSAC
1 – 3 – 4 – 2 180º
Table 7. Injection sequence
2. The TDC of the compression stroke can be obtained by aligning the TDC mark on the crankshaft
pulley with the mark on the gear case.
3. First align the TDC mark for the No.1 cylinder. Confirm that the valves do not move up and
down when the crankshaft is turned about 20º in normal direction of rotation and in reverse
direction.
Ref. 13840110
(13840111 –
replacement kit
without case)