![background image](http://html1.mh-extra.com/html/snell-and-wilcox/iqh1s-1u/iqh1s-1u_installation-manual_1309050068.webp)
IQH1S IU Enclosure
SECTION 4
IQH1SOPS
23/11/06
www.snellwilcox.com
Version 1 Issue 4
4.23
Setup (cont)
Net Show
This function allows a unit to be `hidden' from the
network system.
When netshow is active the unit broadcasts its
presence.
Note that if the unit address is changed Netshow
will automatically be turned On.
Allow Blind Control
If the Gateway will be controlled by Blind Control
then Allow Blind Control must be enabled.
If Blind Control is not used then Allow Blind Control
may be disabled, giving protection against
incorrectly set-up RollTrack sources. Note, if
upgrading the gateway software, you must enable
Blind Control.
Box Type
This item allows the 1U enclosure to be configured
as a ShoeBox or a 3U Box.
Note that when the ShoeBox and 3U selections are
made the templates will be different and some
items will only be usable if the 1U enclosure is
controlling the selected box type.
Where Am I?
This allows the 1U enclosure to be physically
located in a large system.
When this function is selected the TX and RX
LED's on the gateway card will flash.
Serial Port Setup
Speed
This group allows the serial port to be configured.
The baud rate is set between 2400 and 115200
baud.
The default speed for all RollCall serial connections
is 38,400 bps.
NB The RollCall PC software only supports speeds
up to 57600 baud.
TX and RX LED's