![background image](http://html1.mh-extra.com/html/snell-and-wilcox/iqh1s-1u/iqh1s-1u_installation-manual_1309050061.webp)
IQH1S IU Enclosure
SECTION 4
IQH1SOPS
23/11/06
www.snellwilcox.com
Version 1 Issue 4
4.16
Setup
User Levels
The setup of the active front panel may be
accessed at various levels. At the highest level
(Supervisor) access is allowed to all functions. This
level may only be accessed by entering a
password. At lower levels (User and Engineer)
access is only allowed to a limited number of
functions.
As supplied the unit will be in a temporary
Supervisor mode with no password protected
access levels.
Connect to Now
This function allows an immediate connection to be
made to a unit.
RollCall unit address
The RollCall unit address should be typed in and
selecting
(return) will make a connection to that
unit.
Selecting
(return) will return the RollCall unit
address to 0000:00:00.
Supervisor Password (1-8)
The 4-digit supervisor password may entered here.
Note that only numbers in the rage of 1 to 8 may
be used; 0 and 9 cannot be used.
Selecting
(return) will save the new password.
The
preset selection sets the password to
0000.
Lock Controls
When enabled the front panel controls will be
locked.
Note that if this function is enabled and the unit is
powered-up, the message
Front Panel Locked by Supervisor!
will appear.
Invoke command Now
This function allows an immediate command to be
sent to a unit.
Partial*Command
The Partial*Command should be typed in and
selecting
(return) will send the command to
that unit.
Selecting
(return)
will
return
the
Partial*Command to 0*0.
Software Version
This will show the software version followed by the
serial number.