![background image](http://html1.mh-extra.com/html/snell-and-wilcox/iqh1s-1u/iqh1s-1u_installation-manual_1309050060.webp)
IQH1S IU Enclosure
SECTION 4
IQH1SOPS
23/11/06
www.snellwilcox.com
Version 1 Issue 4
4.15
Auto Connect
This function allows a number of units to be
automatically connected to the control panel at
power-up.
Up to 16 units may be designated in this way by
assigning a number to them. (00 to 15)
Note that these numbers are also used to
assign the default unit.
The units in this list are (on power-up) in the
standby mode and although not currently active are
locked to this control panel and may not be
controlled by any other panel.
The network address of the unit is shown in the
text line as three sets of hexadecimal codes.
The first set is the network address, the second set
is the physical unit address and the third set is the
port address.
The code may be changed by typing in the new
code.
The code may be reset to 0000 00 00 by pressing
the
button. This action also removes the unit
name from the display and inserts a ? symbol
indicating that no unit will be connected to this
session.
The Auto Connect set-up may be saved by
pressing
(return).
Default Unit
On power-up the default unit will be automatically
connected, its menus retrieved and will be ready
for active control.
To define the default unit use the scrollbar until the
desired number is reached. (This number is the
number assigned to a particular unit in the Auto
Connect set-up)
The
selection sets the default unit to `None'
Note that only one unit may be designated as the
default unit.