Vega 30 Router User Manual
Preliminary Vega 30 Router Configuration
Getting Started 11.3
Issue1 Revision 1
Page 198
© 2017 SAM
6.
Click ‘Configuration’ in the home page’s navigation side-bar.
The
Configuration
Web page is shown.
On the
Configuration
Web page:
7.
Make network settings changes as required for the Vega 30 Router and your house
network.
(I.e. Vega 30 Router IP address, Sub-net mask, Gateway IP address, and DNS server
1 and 2 IP addresses.)
8.
Set the ‘
PSU Fitted
’ setting to match the PSU configuration to be used.
(I.e. ‘PSU 1 fitted only’, ‘PSU 2 fitted only’, or ‘Both fitted’.)
9.
Click
Apply
.
10. Click
Restart Unit
.
The Vega 30 Router restarts.
11. Disconnect the Vega 30 Router from the PC.
When the Vega 30 Router has restarted, the new settings have taken effect and the Vega 30
Router is ready to be installed in a rack and then connected to using its new IP address etc.
12. Power down the unit and install in an equipment rack. It requires a shallow, 3RU high
rack-space.
13. Earth the unit’s chassis using the Chassis Ground Point, see Figure 141 on page 194.
Figure 144 Vega 30 Configuration Web Page
System Network settings
PSU Fitted
setting
Apply
button
Restart Unit
button
