IQUDC30/IQUDC31/IQUDC32/IQUDC33
Technical Specification
Issue 1 Rev 4
Page 18
© 2016 SAM
2
Technical Specification
Inputs and Outputs
Video Signal Inputs
SDI Inputs
2
Input Cable Length
Up to 80m Belden 1694A @ 3 Gbit/s
Up to 120m Belden 1694A @ 1.5 Gbit/s
100m typical Belden 1694A @ 270 Mbit/s (with output set to 1080p rates)
Input Standard (auto detect)
525i, 625i, 720p23/24/25/29/50/59, 1080i50/59, 1080p23/24/25/29,
1080psf23/24/25/29, 1080p50/59 (A/B).
Note
: Low frame rate support (i.e. 23, 24, 25, 29 Hz) is not available in modules which were upgraded to V5.2.7 or
above after installation. Only new builds of modules at version 5.2.7 and above will support low frame rate signals.
Analog Reference
1 single or 1 passive loop-through, depending on rear panel type
Black (HD tri-level and SD bi-level) and Black Burst (SD bi-level)
SD bi-level – RS170A
HD tri-level – SMPTE 240M, 274M
Audio Signal Inputs
AES Inputs
8 x balanced AES inputs or 8 x unbalanced AES inputs, depending on rear
panel type (AES applicable to IQUDC32 and IQUDC33 only)
Fiber Signal Inputs
Inputs
Up to 2, depending on SFP type fitted
Optical
3 Gbit/s HD-SDI
1.485 Gbit/s HD-SDI
270 Mbit/s SD-SDI
Connector/Format
LC singlemode
Standard
SMPTE 297-2006
Video Signal Outputs
SDI Outputs
Up to 5, depending on rear panel type
Output Standard
525i, 625i, 720p23/24/25/29/50/59, 1080i50/59, 1080p23/24/25/29,
1080psf23/24/25/29, 1080p50/59 (A/B).
Note
: Low frame rate support (i.e. 23, 24, 25, 29 Hz) is not available in modules which were upgraded to V5.2.7 or
above after installation. Only new builds of modules at version 5.2.7 and above will support low frame rate signals.
Payload Identification Codes
Insertion of SMPTE ST-352 payload identification codes for psf standards
Audio Signal Outputs
AES Outputs
8 x balanced AES outputs or 8 x unbalanced AES outputs, depending on
rear panel type (AES applicable to IQUDC32 and IQUDC33 only)
Fiber Signal Outputs
Outputs
Up to 2, depending on SFP type fitted
Optical
270 Mbit/s SD-SDI
Connector/Format
LC singlemode
Standard
SMPTE 297-2006
Control Interface
GPI
2 x closing contact I/O interface (ST), depending on rear panel type
