IQUDC30/IQUDC31/IQUDC32/IQUDC33
Operation Using the RollCall Control Panel
Issue 1 Rev 4
Page 52
© 2016 SAM
5.5.5 Output Cadence
The Output Cadence controls enable you to define the required cadence of the output video.
•
Film Cadence
- Enable if the output content is required to have a film cadence
associated with it. Default = Off
•
59 Cadence
- If the output is to have a film cadence associated with it and its frame
rate is 59.94Hz, then the cadence should be defined as either
•
2:3 (Default)
•
2:2 (psf)
•
2:3 Source
- In circumstances where the output is defined as 59.94 2:3, this control
allows the user to decide if they wish to control the starting point of the 2:3 sequence
with respect to timecode.
•
When set to
Free Run
(Default) the output 2:3 cadence starting point is not
defined. The output will have continuous 2:3, but may vary from conversion to
conversion.
•
When set to
Output Timecode
, the user defines the point where the 2:3
sequence starts relative to timecode.
•
2:3 Start Hour
- This control allows the user to define the starting position of the 2:3
sequence with respect to timecode. It is only active when 2:3 Source is set to Output
Timecode.
Control is available from 1 hour to 23 hours in steps of 1 hour. Default is 1 hour.
Note:
Cadence support is only available to modules released at V5.2.7 and above. Earlier
modules which were upgraded to V5.2.7 after installation will not support cadence control.
