IQUDC30/IQUDC31/IQUDC32/IQUDC33
Operation Using the RollCall Control Panel
Issue 1 Rev 4
Page 44
© 2016 SAM
5.3.10 Logo Control (Option)
When the optional logo inserter is installed, additional controls are available.
•
Logo control
- Lists the available logos that have been uploaded to the unit via the
separate logo installation application (see Appendix 2). The currently selected logo is
highlighted.
•
Load
: Click Load to load the selected logo.
•
Take
- Displays the logo.
•
H position
- H position determines the horizontal placement of the logo from 0% (left
edge of picture) to 100% (the logo's furthest edge is on the picture right edge), in
steps of 1%.
Preset is 10%.
•
V position
- V position determines the vertical placement of the logo from 0% (top of
picture) to 100% (the logo's bottom edge is on the picture bottom edge), in steps of
1%.
Preset is 10%.
•
Transparency
- Transparency allows you to adjust the visibility of the logo from 0%
(fully visible) to 100% (invisible) in steps of 1%.
Preset is 10%.
•
Pre-shaped
- Indicates if the logo is pre-shaped (see Appendix 2)
•
Delete
- Deletes the highlighted logo.
•
State
- Indicates if a logo has been loaded and is ready for display.
•
Logo selected
- Indicates the name of the logo currently being displayed.
Note:
When using the logo insertion feature with input and output signals of the same frame rate
and format, ensure that Sync Mode (see section 5.6.1) is enabled to preserve output
quality.
Note:
For a logo to be deleted, it must first have been loaded.
