IQUDC30/IQUDC31/IQUDC32/IQUDC33
Technical Specification
Issue 1 Rev 4
Page 20
© 2016 SAM
Processing Functions (per channel on IQUDC31 and IQUDC33)
Freeze
On/Off
Legalizer
Off, 700mV, 721mV, 735mV, 746mV
Genlock
Reference Lock, Input Lock, Free Run
Pattern
Off, Black, Ramp, Bars
Caption
On/Off, Scrolling
Edit Caption
19 characters available
Proc amp
Black Level
+100 mV to -100 mV (0) in 0.8 mV steps
Contrast
-6dB to +6 dB (0) in 0.2 dB steps
Saturation
-6dB to +6 dB (0) in 0.2 dB steps
Y Gamma
0.4 to 1.7 (1) in 0.1 steps
YC Offset
-20 to 20 (0) in 2 luma pixel steps
Note: Defaults shown in brackets
Enhancement
Nonlinear Enhancer
Frequency Band Selection: Low, Med, High
Four preset enhancement modes: Low, Med, High, Super
Manual enhancement mode with H Gain and H Noise Rejection levels
Conversion Aperture
Vertical
Frequency Band Selection: Low, Med, High
Five vertical preset enhancement levels: Soft 2, Soft 1, Normal, Sharp 1,
Sharp 2
Horizontal
Five horizontal preset sharpness levels: Low 2, Low 1, Normal, High 1,
High 2
Five horizontal preset detail levels: Soft 2, Soft 1, Normal, Sharp 1,
Sharp 2
Other Controls
GPI Input Low/High Select
Black, Freeze, Pattern, User Memories 1–16
GPI Output Source
Black, Freeze, Pattern
Memory Naming
User configurable naming of memories 1–16
RollTrack Index
Up to 50 RollTrack destinations
Optical Logging
Tx Laser Bias High Warning
Tx Power Low Warning
Tx Power High Warning
Laser Wavelength
Input 1 (2) Rx Power High Warning
Input 1 (2) Rx Power Low Warning
Input 1 (2) Rx Power Measurement
RollTrack Sources
Unused, Input Present, (1 & 2, Fiber 1 & 2), Input Loss (1 & 2, Fiber 1 & 2),
Reference OK and Loss
Information Window
Video Input Status, Video Output Status, Audio Status, Metadata Status,
Reference Status
Factory Default
Resets all module settings to factory defaults and clears memories
Default Settings
Resets all module settings to factory defaults but does not clear memories
Module Information
Software Version, Serial Number, Rear Panel ID, Frame Slot
